FEATURES |
---|
– 2.5 Gallon VIAIR Air Tank |
– 400C VIAIR Compressor w/Thermal Overload Protector |
– 35ft. Coil Hose with Tire Chuck |
– 1/4” Quick Connect Stud (F) |
– 1/4” Quick Connect Coupler (F) |
– Dash Panel Gauge with ON/OFF Switch |
– Pressure Switch with Relay (110 PSI on, 145 PSI off) |
– Reducer: 1/8” (F) to 1/4” (M) |
– 1/4” 175 PSI Safety Valve |
– 1/4” Drain Cock |
– (3) 1/4” Compression Fittings |
– 20ft. 12-Gauge Wire with Inline Fuse Holder |
– 4” Strip of Continuous Grommet Material |
– Accessory Airline |
– Electrical Connections |
SPECIFICATIONS |
---|
– 12-Volt |
– Permanent Magnetic Motor |
– Duty Cycle: 33% @ 100 PSI |
– Max. Working Pressure: 150 PSI |
– 1/4” Quick Connect Coupler (F) |
– Max. Amp Draw: 30-Amps |
– Ingress Protection Rating: IP67 |
– Max Ambient Temp: +158°F |
– Min Ambient Temp: -40°F |
– |
– |
– |
– |
– |
– |
All Fittings are NPT rated unless otherwise noted.
Wiring harness NOT included.
Please Note: Pressure Switch w/Relay (PNs 90110, 90111, 90113, 90118) is not a sealed unit and should be installed in an area protected from the elements to prevent damage and/or failure.
Please Note: Use thread sealant for proper installation. Thread tape is not recommended.
Properly sealed, recommended torque for 1/8” is 10 ~ 11 ft. lbs. Recommended torque for 1/4” and 3/8” is 16 ~ 18 ft. lbs.
PERFORMANCE DATA
PSI | CFM | A | BAR | LPM | A |
---|---|---|---|---|---|
0 | 2.62 | 16 | 0 | 74 | 16 |
10 | 2.39 | 18 | 1.0 | 65.0 | 20 |
20 | 2.21 | 20 | 2.0 | 60.0 | 23 |
30 | 2.11 | 22 | 3.0 | 56.0 | 25 |
40 | 2.01 | 24 | 4.0 | 53.0 | 27 |
50 | 1.93 | 25 | 5.0 | 49.0 | 28 |
60 | 1.84 | 26 | 6.0 | 46.0 | 28 |
70 | 1.73 | 27 | 7.0 | 42.0 | 28 |
80 | 1.65 | 27 | 8.0 | 38.0 | 28 |
90 | 1.52 | 27 | 9.0 | 35.0 | 27 |
100 | 1.45 | 27 | 10.0 | 31.0 | 27 |
110 | 1.35 | 27 | |||
120 | 1.26 | 27 | |||
130 | 1.19 | 27 | |||
140 | 1.08 | 27 | |||
150 | 1.01 | 26 |
* Supply Voltage: 13.8 Volts
FILL RATES
2.5 Gallon Tank | Fill Rate |
---|---|
0 to 145 PSI | 2 min. 20 sec. (± 05 sec.) |
110 to 145 PSI | 48 sec. (± 03 sec.) |
33″ x 12.5″ | Fill Rate |
0 to 30 PSI | 4 min. 20 sec. (± 10 sec.) |
15 to 30 PSI | 2 min. 05 sec. (± 05 sec.) |
35″ x 12.5″ | Fill Rate |
0 to 30 PSI | 5 min. 20 sec. (± 15 sec.) |
15 to 30 PSI | 2 min. 45 sec. (± 10 sec.) |
RV Tires 275/80r22.5 | Fill Rate |
80 to 90 PSI | 30 sec. (± 05 sec.) |
90 to 100 PSI | 3 min. 50 sec. (± 10 sec.) |
110 to 130 PSI | 4 min. 37 sec. (± 15 sec.) |
Watch our Step by Step instructions on how to install your VIAIR On-Board Air System below
To read our complete installation article. Click Here.
NOTE: The installation instructions in this video are only applicable to single-compressor onboard air systems (Part Numbers: 10003, 10005, 10007, and 20001). For other OBA’s, the wiring is different. If you have installation questions, please contact our customer service team.