Ultra-Light Duty OBA
For Air Horns & Air Lockers
P/N 10000 – 105 PSI / 1.53 CFM
Ultra Light Duty Onboard Air System can be used to pressurize the included 1.0 gallon air tank for air horn use, air lockers, and a host of other light duty pneumatic needs. While not intended for tire inflation, this onboard air system provides a reliable air source in a smaller volume, and a cost effective package.
Please Note: Use thread sealant for proper installation. Thread tape is not recommended.
Properly sealed, recommended torque for 1/8″ is 10 ~ 11 ft. lbs.
Recommended torque for 1/4″ and 3/8″ is 12 ~ 15 ft. lbs.
| FEATURES |
|---|
| – 1.0 Gallon VIAIR Air Tank |
| – 98C VIAIR Air Compressor |
| – Omega Bracket with Mounting Hardware |
| – Pressure Switch (85 PSI on, 105 PSI off) |
| – 40-amp Relay |
| – 145 PSI Safety Valve |
| – T-Fitting: 1/4” (M) x 1/4″ (F) x 1/8” (F) |
| – T-Fitting: 1/4” (M) x 1/4″ (F) x 1/4” (F) |
| – 1/4” Drain Cock |
| – 1/4” Compression Fitting |
| – 1/4” Plug (M) |
| – (2) 1/4” (M) NPT to 1/8” (F) BSP |
| – 20ft. 16 Gauge Wire with Inline Fuse Holder |
| – Accessory Airline |
| – Electrical Connections |
| SPECIFICATIONS |
|---|
| – 12-Volt |
| – Permanent Magnetic Motor |
| – Duty Cycle: 10% @ 100 PSI |
| – Max. Working Pressure: 105 PSI |
| – Max. Amp Draw: 12 Amps |
| – Ingress Protection Rating: IP54 |
| – |
| – |
| – |
| – |
| – |
| – |
| – |
| – |
| – |
All Fittings are NPT rated unless otherwise noted.
Wiring harness NOT included.
PERFORMANCE DATA
| PSI | CFM | A | BAR | LPM | A |
|---|---|---|---|---|---|
| 0 | 1.53 | 7 | 0 | 43.5 | 7 |
| 10 | 1.00 | 9 | 1.0 | 28.0 | 9 |
| 20 | 0.95 | 10 | 2.0 | 25.5 | 11 |
| 30 | 0.90 | 11 | 3.0 | 22.7 | 11 |
| 40 | 0.83 | 11 | 4.0 | 20.7 | 12 |
| 50 | 0.77 | 12 | 5.0 | 18.3 | 12 |
| 60 | 0.72 | 12 | 6.0 | 16.3 | 12 |
| 70 | 0.65 | 12 | 7.0 | 13.7 | 12 |
| 80 | 0.60 | 12 | 8.0 | 11.7 | 12 |
| 90 | 0.54 | 12 | 9.0 | 10.0 | 11 |
| 100 | 0.48 | 12 |
* Supply Voltage: 13.8 Volts
FILL RATES
| 1.0 Gallon Tank | Fill Rate |
|---|---|
| 0 to 105 PSI | 1 min. 40 sec. (± 10 sec.) |
| 85 to 105 PSI | 30 sec. (± 05 sec.) |
USER MANUAL
WIRING DIAGRAM
PLUMBING DIAGRAM
DIMENSIONAL DRAWING
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
